Bounce Ride Instructions

SITE LAYOUT

1. Pick a location free from overhead electrical power or telephone lines.  Location should be free from trees that could damage or stain the inflatable ride.  An unobstructed area should be maintained for 5 feet around the perimeter of the Ride.

2. Contact all utility companies and have all underground utility lines properly located so no accidental contact occurs when driving stakes.

3. Ensure there are no underground irrigation pipes or other utilities that the property owner has installed.

4. Place your ground liner over the site where you want the Ride.

5. Keep the front of the Ride clear and accessible at all times.

INSTALLATION

1. Unroll and position the Ride on the liner with the inflation tube located to the rear of the Ride.  NOTE:  The rear of the Ride will be where you started unrolling.

2. Stake the Ride before inflating.  Be sure the stake heads are away from the inflatable portion to avoid abrasion.

3. Place the blower fan with GFI on a dry flat surface, connect to the Ride's inflation tube.  Either tube can be used.

4. Connect a properly sized extension cord(12 gauge) to the GFI, then plug into the power outlet.

5. Check the inflation tube to make sure it is properly attached to the blower fan.  

6. Close the exhaust tube to 2 inches in diameter.  then, hold closed with hand.

7. Turn on Blower.  When fully inflated release exhaust tube leaving only a 2 inch diameter outlet.

SAFETY RULES

1. Do not inflate in high winds or rain.

2. Unload all occupants and deflate the ride if wind becomes excessive.

3. Limit Number of occupants to the number specified on label.